Description

PLASTIC CENTRED PNEUMATICS WITH BUTYL RUBBER SEAMLESS TUBES:

• Thick sections, large radii, multi-web design for strength (stronger than most imported steel centres)
• Corrosion resistant polypropylene with UV fade protection
• High engineering standards for wobble-free wheels
• High quality butyl rubber seamless (butt-joined) tubes

BEARINGS:

‘Deep Groove’ shielded bearings fitted to a toughened heavy duty housing enables true running and extra strength (NOTE: Deep groove bearings can last up to 3 times longer than normal pressed bearings).

TYRES:

4 ply for longer, rougher life (many imports use 2 ply).

For wheels pulled or pushed at low speeds (not driven) the tread pattern is not critical. The following are standard; other patterns can be offered by negotiation.

• RIB: Straight lines along the tread, common on wheelchairs.
• LUG: General purpose, outside use. Strongly marked cross lines on a fairly flat tread surface.
• Good for running in a straight line.
• LGG: Grey rubber LUG – non-marking of floors
• IND: The normal industrial tread, a round profile with an even pattern for general use.
• DMD: Diamond shaped pads on a flatter surface. Often used in rougher construction sites. Good for softer grassed surfaces, but may become clogged with mud.
• KNO: This knobbly pattern is often preferred for outdoor use, where its strongly marked tread takes a good grip on soft ground.
• ZGG: Grey rubber zig zag – non-marking of floors

TUBES

Tubes are high quality butyl rubber seamless (butt-joined) for premium ride quality, high load capacity and long life.

Additional information